Three types of natural selection

Natural selection is not always a mechanism for change. There three different types: stabilising selection, directional selection, and disruptive selection. These are three different ways in which natural selection acts on the phenotypes in a population (the observable characteristics such as colour or height). Typically, the frequency in the population of each phenotype has a normal distribution, described by a bell-shaped curve .

Stabilising selection happens in an unchanging environment. Extremes of the phenotype range are selected against, leading to a reduction in variation (more individuals tend to conform to the mean). Stabilising selection occurs in the natural selection of birth mass in humans.

Directional selection favours one extreme of the phenotype range and results in a shift of the mean either to the right or to the left. This type of selection usually follows some kind of environmental change. The long neck of the giraffe is thought to have evolved in this way. Probably, when food was in short supply, only the tallest individuals could reach enough food to survive. They passed on their genes to the next generation.

Disruptive selection selects against intermediate phenotypes and favours those at the extremes. This leads to a bimodal distribution(the distribution curve has two peaks or modes) and two overlapping groups of phenotypes. If the two groups become unable to interbreed, then each population may give rise to a new species. Disruptive selection may have contributed to the evolution of Darwin’s finches. Because there were few other birds to compete, finches with short strong beaks had exclusive use of nuts as a food source, while those with long slender beaks had almost exclusive use of insects. Those finches with an average, unspecialised beak were more likely to have been in completion with other species of bird and would have reproduced less successfully.